CangDao CD-AS-01 Tian Wei Dragon Spear 1/100 Build Tips

Quick Answer

Build your CangDao CD-AS-01 Tian Wei Dragon Spear with confidence by following these six steps that address the metal frame's fit, the spear's stability, and the decal application.

Assembly Steps for a Flawless Build

1. 1. Prep the Metal Frame Joints: Before snapping any plastic part onto the metal frame, check each peg hole for burrs or paint overspray. Use a fine file or 1000-grit sandpaper to gently clean the opening. A dry fit without glue or cement will tell you if the connection is too tight. Skipping this step can crack the plastic peg when you push it onto the metal.
2. 2. Build the Torso Sub-Assembly First: Assemble the chest and waist unit before attaching the arms or legs. The metal frame here is the kit's structural anchor. Make sure the hip joint clicks fully into place—listen for the positive lock. If it feels loose, a tiny drop of thick CA glue on the male side will tighten it. A wobbly torso will make every pose frustrating; get this solid first.
3. 3. Reinforce the Dragon Spear Grip: The spear is a single large piece with a hand peg. Wrap one layer of Teflon tape around the peg before inserting it into the palm. This creates friction without permanent modification. Test the grip by holding the kit upside down—if the spear drops, add another layer. The spear looks great but is heavy; a loose grip will ruin dynamic poses.
4. 4. Apply Decals After a Matte Topcoat: Spray a thin layer of matte clear coat over the assembled plastic parts (mask the metal frame). Let it cure for 2 hours, then apply the water-slide decals with a soft setter solution. The matte surface gives the decals better adhesion and reduces silvering. Decals on bare gloss plastic will peel off when you handle the kit.
5. 5. Pose and Balance the Completed Kit: Once fully assembled, adjust the joints starting from the feet upward. The metal frame makes the kit bottom-heavy, so spread the legs slightly wider than shoulder-width for stable standing poses. For action poses, use the included display base—the spear's length can tip the center of gravity forward. The kit is heavier than a typical 1/100 plastic model; always test balance before leaving it unattended.

Kit Highlights

• CangDao CD-AS-01 1/100 Tian Wei Dragon Spear Metal Frame Model Kit: The CangDao CD-AS-01 Tian Wei 'Patrolman' Dragon Spear is a 1/100 scale original mecha model kit with a metal frame, designed as a celestial guardian-patrol unit with a dragon-themed spear. The metal frame gives the kit a premium feel and stable core, but the tighter tolerances mean you should test-fit every joint before applying force to avoid stress marks.