Nonzero Hemoxian Thor Model Kit Build Impressions
By Fuwa Fuwa Land-Fuwa Fuwa Land | Published: 2026-10-19
Category: How-to Guides
First-hand build impressions of the Nonzero Hemoxian NZS-05-3 Thor kit. Practical assembly tips for this 1/100 scale third-party mecha model from The Entropy of Gods series.
Quick answer
The Nonzero Hemoxian NZS-05-3 Thor kit delivers a rewarding build with a metal frame and detailed armor, but requires careful part trimming and dry-fitting to avoid fit issues.
Why this kit stands out among third-party models
The Hemoxian NZS-05-3 Thor is part of Nonzero Studio's The Entropy of Gods series, blending Norse mythology with futuristic mecha design. At 1/100 scale and 22.5cm tall, it offers a substantial presence. The included metal frame adds weight and stability, a feature often missing from budget third-party kits.
However, being a third-party kit, it lacks the polish of official Bandai releases. Expect some flash on parts and tighter tolerances that require sanding or trimming. This is not a snap-fit kit; patience and basic modeling tools are essential.
What to prepare before starting
You will need a hobby nipper, a hobby knife, sandpaper or files, and plastic cement. The metal frame parts may need light sanding to fit into plastic sockets. A small pin vise can help if any peg holes are too tight. Work on a clean, well-lit surface to avoid losing small parts.
Step-by-step build tips for the Thor kit
- 1. Sort and inspect all runners: Lay out the runners and check against the manual. Identify the metal frame parts separately. Look for any warped or short-shot pieces. Common mistake: assuming all parts are present. Count pieces early to avoid mid-build surprises.
- 2. Clean nubs and flash carefully: Use a hobby nipper to cut parts from the runner, leaving a small nub. Trim flush with a hobby knife, then sand smooth. Pay extra attention to connection points on the metal frame. Checkpoint: test-fit each joint before gluing. If it's too tight, sand the peg slightly. If too loose, apply a thin layer of plastic cement to thicken it.
- 3. Dry-fit sub-assemblies before final assembly: Assemble the torso, arms, and legs without glue first. Check that all joints move freely and that armor panels align. Mark any areas that need adjustment. Common mistake: gluing too early can lock you into misaligned parts. Dry-fitting saves rework.
- 4. Apply cement sparingly to stress points: Use plastic cement on joints that bear weight or see frequent movement, such as hip and shoulder connections. Avoid cement on cosmetic panels unless they are loose. Checkpoint: let cement cure fully (24 hours) before posing the kit. Rushing can weaken bonds.
- 5. Pose and display with care: Once assembled, the Thor kit is a display piece. Its metal frame gives it a solid feel, but repeated posing may wear down plastic sockets. Choose a dynamic pose and leave it. Common mistake: over-posing can cause joint loosening. Set your final pose early.
Kit highlights
- Nonzero Hemoxian 1/100 NZS-05-3 Thor The Entropy of Gods Model Kit: Released by Nonzero Studio under the highly acclaimed 'The Entropy of Gods' series, this 1/100 scale original mecha model kit completely redefines the expectations for third-party plastic models. The series reputation means you get a thoughtfully engineered design with a metal frame, but you still need to treat it as a builder's kit, not a toy.
Nonzero Hemoxian 1/100 NZS-05-3 Thor The Entropy of Gods Model Kit
